Registering as a Provider

To register on the mev-commit network, providers need to stake ETH in the provider registry contract. This adds credibility to issued commitments, as stake may be slashed in the event of a broken commitment, such as committing to a preconfirmation bid and not including the relevant transaction in a block.

Once a provider is registered on the network, other nodes will connect to it, and the provider node will receive bids.

You can use the provider API to stake and check your stake balance.

1. Fund Account

   Make sure you’ve funded your account on the mev-commit chain first.

2. Check Minimum Stake Amount

   Check the minimum amount that can be staked, and consider staking more than the minimum. Bidders will only connect to providers which have stake higher than this minimum. The larger a provider’s stake, the greater the credibility behind that provider’s commitments. The amount is set in wei.

   > curl localhost:13523/v1/provider/get_min_stake | jq
   {
     "amount": "1000000000000000000"
   }
   
3. Stake

    > curl -X POST localhost:13523/v1/provider/register_stake/10000000000000000000 | jq
    {
      "amount": "10000000000000000000"
    }
   

   Once staked, peer connection logs should appear within a few minutes. You can check the /topology endpoint again to verify connected peers.

Other commands that can be used are:

• Check stake balance

  > curl localhost:13523/v1/provider/get_stake | jq
  {
    "amount": "0"
  }
  

• Get the account address of your node

  > curl localhost:13523/topology | jq
  {
    "self": {
      "Addresses": [
        "/ip4/127.0.0.1/tcp/13522",
        "/ip4/172.29.0.4/tcp/13522"
      ],
      "Ethereum Address": "0xB9286CB4782E43A202BfD426AbB72c8cb34f886c",
      "Peer Type": "provider",
      "Underlay": "16Uiu2HAmDWZb4DxZQkS9yseXNukBFe6MhZdimSKuZcHFeJrF3jC9"
    },
    "connected_peers": null,
    "blocked_peers": null
  }
  

Congrats! Your provider node is registered on mev-commit, and you’re ready to consume bids.